why..

[downstairs]

i just bought some new arrow racing tires (launch model) and it wont seal onto the rim? any suggestionsa on how to get iut to stay on?

[*GiMpY_jR*]

glue!!!!!!!!! hmm ive never had any probs..... bike shop!?

[Trini-dad72]

Over-inflate it tonight. It should seat itself at some point, and seal up good. Just remember to release some air before you ride it though.

[downstairs]

so i would half to do this every time because i wouldnt wanna wait a few hours if i flatted for it to seal in

[levon]

ride around on it the tire is prob just new and u can wear it in??? dont do any thing hard core like case a curb tho lol :) run low psi for that aswell should seat :)

[.Robinson]

just use duck tape.......it s mans best friend...

[cookedbananas]

what kinda rim are you using? me and my friend both ride launches, but i use rhynolite XLs and he uses doubletracks (hack :) ) hmmmm... not sure whats up.

[Tonestar]

I had the same problem with my Arrow, you just have to pull hard on the side of the tire until the bead catches properly. They have 2 levels on the sidewall for different width rims (I think), do this with low air pressure, it is easoer to flex the tire.

[downstairs]

Originally posted by Tonestar
I had the same problem with my Arrow, you just have to pull hard on the side of the tire until the bead catches properly. They have 2 levels on the sidewall for different width rims (I think), do this with low air pressure, it is easoer to flex the tire.

i did but when one side cathces other side goes out........ i rode around with it on low pressure to and still dont work